TUTORIEL - Sega Dreamcast - VA0 (Rev0) : Modification complète pour GDEMU

[Xrider]

Hi,
First off - thanks for the tutorial @Xrider , i recently purchased a Dreamcast from ebay and received a VA0 model and thought I would be stuck.

I was hoping you might have a higher res image of the 502 pads? I've removed both the 501 and 502 memory chips but i think i have lifted a pad on pin 31.

Not sure if this pin is connected to the footprint or the via on the other side of the footprint?

Hello @gl6171

First of all, thank you for your kind words and compliments, I’m glad the tutorial helped you with your VA0 Dreamcast modification.
Yes, this point is connected on both sides, as shown in the photo below.

[gl6171]

Hello @gl6171

First of all, thank you for your kind words and compliments, I’m glad the tutorial helped you with your VA0 Dreamcast modification.
Yes, this point is connected on both sides, as shown in the photo below.

thanks again. Another question sorry - in the image below i can see you have the reset pin (#1) on the MX29LV160TMC connected to a pad but you haven't mentioned it in the instructions? is this necessary?